(267) 389-9644
Close-up of an old brick wall with worn bricks and rough, eroded mortar joints

Chimney Repair From Center City to Lancaster County

Water and frost are behind most of the repairs we see here. For 2026, sealing crown cracks usually costs $150 to $550, a flashing repair $300 to $1,500, repointing the stack $500 to $2,500 and spalled brick work $1,000 to $3,500.

Rain is steady across our area, 42 to 52 inches a year at NOAA's stations from Lancaster to Center City. What changes is the cold. Center City averages about 62 nights a year at or below freezing; Norristown about 107, Doylestown 106, Lancaster's airport 109, and the station near West Chester 131. By our own count from those normals, a suburban chimney goes through roughly 85 to 115 freeze-thaw swings a year against about 50 downtown, and each swing works water deeper into cracked crowns and open joints.

The house matters as much as the weather. Philadelphia brick has a hard outer face over a much softer interior, the City's Rowhouse Manual notes, so a chipped face or a hard cement patch can start the brick crumbling from inside. Bucks and Chester County stone houses have their own mortar needs. It begins with a free inspection; we take pictures and price every item on paper, so you can fix the urgent things first and plan the rest.

When to call

  • Cracked or crumbling concrete on top of the chimney
  • Mortar joints recessed, sandy or missing
  • Brick faces popping off and landing on the roof or in the yard
  • Brown marks on the plaster beside the chimney
  • White staining on the brick, or rust on the damper
  • A leaning stack or loose top courses

The visit, step by step

  1. Free inspectionTop to bottom, with photos of every problem we find.
  2. Written prices by itemEach repair priced on its own, with what is urgent and what can wait.
  3. Permit checkWe check what your city, township or borough requires before work starts.
  4. Repair and photosWe do the work and send you before and after photos.

The common repairs and what they cost

Crown crack sealing typically runs $150 to $550. Flashing repair runs $300 to $1,500. Plan on $500 to $2,500 to repoint the stack and $1,000 to $3,500 to swap out spalled brick. A new crown, full flashing replacement or a rebuild from the roofline are bigger jobs with their own pages and ranges.

Those are typical 2026 ranges, and your price comes from the inspection, not from this page. Height, roof pitch, slate versus asphalt, the number of flues and how far the damage has spread all move it.

Soft brick, hard mortar

For old masonry most people turn to the Park Service's Brief 2, and its core idea is short: the new joint should be the weaker part of the wall and the one that breathes best. A joint harder than its brick has no flex, and the brick breaks instead. Portland-heavy patches on old Philadelphia chimneys are among the most common causes of the crumbling brick we find.

That is why we match the mortar to the brick and never coat an old chimney in cement or tar. The Historical Commission's Diamond Street manual says the same: covering masonry chimneys with tar, cement or stucco is not recommended.

Does a chimney repair need a permit?

In Philadelphia, L&I's building permit page says that as long as your property is not on the historic register, you often don't need a permit for regular maintenance such as pointing masonry. Major repairs and demolition need one, and chimney extensions and heating appliance work need permits too. If the house is on the register, pointing is an alteration and goes to the Historical Commission first.

Outside the city, Pennsylvania's Uniform Construction Code leaves many repairs to local ordinance, so the answer depends on your township or borough. We check what yours requires before any work starts.

Answers

Chimney Repair questions

What do chimney repairs cost in Philadelphia?

It depends on what is wrong. Typical 2026 ranges are $150 to $550 to seal a crown, $300 to $1,500 for flashing repair, $500 to $2,500 to repoint the stack and $1,000 to $3,500 for spalled brick. The inspection is free and gives you a price for your own chimney.

Should I hire a roofer to fix my chimney?

A roofer is the right call for the roof. Crowns, mortar, brick, flues and caps are masonry and venting work. Leaks at the chimney are often a mix of both, so we look at the flashing and the masonry together.

Can I keep using the fireplace if the chimney has cracks?

It depends where they are. A crack in the crown or outer brick is mostly a water problem. A crack inside the flue can let heat and gases reach framing. Until you know which, it is safer not to light a fire.

How does winter weather damage a chimney?

Water soaks into brick, mortar and crown cracks, freezes, expands and pushes them apart, then thaws and soaks in deeper. NOAA's normals show suburban stations with roughly twice as many freezing nights as Center City.

How do I keep repair costs down?

Fix water problems early. Sealing a cracked crown or repointing a few joints costs far less than replacing spalled brick or rebuilding the top of the stack. Capping the flue stops rain from falling in, and looking once a year finds small problems early.

Rooftops of brick row houses in the foreground with the Center City Philadelphia skyline behind, on a sunny day

Schedule

Choose a morning or an afternoon.

Sunday through Friday, arrival between 8 and 11, 11 and 2, or 2 and 5. The look costs nothing, and a person phones you the day before.

Or call (267) 389-9644

Call (267) 389-9644