
Chimney and fireplace service in Montgomery County
Prewar boroughs, oil-heated river towns and 1970s subdivisions all sit in one county. Our inspection is free and every price is written first.
Montgomery County is younger than the city on average, with a median home built in 1973 and 15.4 percent of homes dating to 1939 or earlier in the Census Bureau's 2024 survey. That average hides a sharp split. The older boroughs and inner suburbs are prewar: 59.3 percent of Jenkintown's homes and 58.1 percent of Glenside's predate 1940, along with 38.9 percent in Pottstown, 35.9 percent in Conshohocken, 34.5 percent in Ambler and 32.9 percent in Norristown. Out toward Collegeville the picture flips, and only 4.8 percent of homes are that old.
The heating mix splits the same way. Countywide, 51 percent of homes use utility gas, 12.9 percent fuel oil and 4.6 percent propane, and about 2,200 homes heat mainly with wood. Some boroughs lean much harder on oil: 36.1 percent of Pottstown's homes, 37.3 percent of Souderton's, 29.1 percent of Royersford's and 21.1 percent of Lansdale's. Oil heat means a boiler or furnace flue in the chimney, and very often a conversion to gas at some point.
Norristown, Conshohocken and the river-town rows
Norristown is the county's rowhouse borough: 47.1 percent of its homes are rowhouses, twins or townhouses, and Conshohocken is close behind at 43.7 percent. On a row of narrow brick houses, chimneys sit close together near the party walls, and one stack often carries more than one flue. We inspect each flue separately, note which appliance it serves, and photograph the top, the crown and the flashing. Where two houses share a stack, who looks after which part depends on the flues and on your deeds; we document both sides so neighbors can work from the same photos.
The usual jobs on these stacks are repointing in a soft mortar, a new crown that sheds water, and a liner for a heater flue. A new crown with a drip edge typically costs $800 to $2,500, and repointing the stack $500 to $2,500.
Oil boilers, conversions and the orphaned water heater
When a house moves from oil to gas, or trades an old boiler for a high-efficiency model piped through the side wall, the chimney is usually the part nobody thinks about. The 2021 International Residential Code, in force in Pennsylvania since January 1, 2026, expects the flue to be resized whenever unhooking an old appliance or tying in a new one would leave it prone to exhaust condensation. It also says the chimney must be examined, and cleaned if it vented oil or wood, before a new gas appliance is connected to it.
The classic case is a gas water heater left alone in a large flue built for an oil boiler. Its small, cool exhaust can't warm the flue enough, water condenses inside, and the clay and mortar suffer. A stainless furnace or boiler liner sized to what remains typically costs $2,100 to $3,800. Gas customers in the county are served by PECO, whose advice on a gas smell is to leave the house and call 800-841-4141 from at least 100 feet away.
Freezing nights from Norristown to Pottstown
NOAA's 1991–2020 normals put Norristown at about 107 nights a year at or below freezing and the Pottstown Limerick airport at about 111, with 25.3 inches of snow a year at Norristown. Center City Philadelphia, for comparison, averages 62 freezing nights. Each night that drops below freezing after a wet day pushes water in cracked crowns and open joints a little further.
That is why a crown that looks like a thin mortar wash, with no overhang, is the first thing we point out on many older Montgomery County chimneys. Under current code the crown can be concrete, metal or stone; it should pitch so water drains off, carry a drip edge, and stay separated from the flue liner by a sealant-filled gap. Sealing small crown cracks typically costs $150 to $550.
- Glenside and Jenkintown: prewar brick, wood fireplaces, soft mortar.
- Norristown, Conshohocken, Ambler: rows and twins with shared stacks.
- Pottstown, Souderton, Royersford, Lansdale: oil flues and conversions.
- Collegeville, Blue Bell, Horsham: newer homes, gas fireplaces and factory-built chimneys.
Answers
Montgomery County questions
We converted from oil to gas. Does the chimney need work?
Often it does. Pennsylvania's code says the chimney must be examined and cleaned before a gas appliance is connected to a flue that vented oil, and resized as needed when appliances are added or removed. We check this at the free inspection and write down whether a liner is needed and what it costs.
Our furnace now vents out the wall. What about the water heater?
If the gas water heater still uses the old chimney by itself, the flue is probably far too big for it. That is the case the code's resizing rule is written for. Most often the answer is a stainless liner matched to that heater.
Do you work in Pottstown and the upper county?
Yes. We work across Montgomery County, including Pottstown, Royersford, Collegeville, Harleysville, Souderton and Lansdale, as well as Norristown, Glenside, Jenkintown, Ambler and the towns along the city line.
Do I need a permit for chimney repair in Montgomery County?
Rules differ between townships and boroughs, and Pennsylvania's code leaves many plain repairs to local ordinances. Appliance and venting work generally needs a permit. We check what your municipality requires before any work starts.
What does the inspection cost?
Nothing. We look at the chimney from inside and from the roof, photograph what we see, and put a price in writing on any repair before work begins. Local companies that publish prices charge $69 to $500 for an inspection; ours is free.
Schedule
Choose a morning or an afternoon.
Sunday through Friday, arrival between 8 and 11, 11 and 2, or 2 and 5. The look costs nothing, and a person phones you the day before.
