(267) 389-9644
Three-story colonial stone house on a street corner in Newtown, Pennsylvania

Chimney repair for Glenside's prewar houses

Close to six in ten Glenside homes were built before 1940. We repoint, recrown and reline those chimneys, and the inspection is free.

Few places near Philadelphia have housing this old. The Census (ACS 2024) puts 58.1 percent of Glenside's roughly 2,900 homes in 1939 or earlier; the median home is old enough that the Census simply tops it out at 1939. For comparison, the share for Montgomery County as a whole is 15.4 percent. Only 18.9 percent are attached houses, and gas heats 71.7 percent of homes.

Glenside straddles two townships, Abington and Cheltenham. Wikipedia traces the name to 1888, when the post office opened and the old Abington Station, first built in 1855 as Tacony Station, was renamed Glenside. With so much prewar housing, many Glenside chimneys are close to a century old, and that is the starting point for our free inspection.

Hundred-year-old chimneys and soft mortar

A chimney built before 1940 was usually laid in a lime-rich mortar, and the brick behind its face is softer than modern brick. The Park Service's guide to repointing wants new joints weaker and more breathable than that brick, and never harder than the lime mortar first used. A hard cement patch traps water in the brick, and the brick face pops off instead of the joint. Repointing a stack typically runs $500 to $2,500, spalling brick or failed stone repair $1,000 to $3,500.

Old crowns are often a thin mortar wash rather than a real cap. Today's code wants a crown of concrete, metal or stone that tips water off its edges, overhangs with a drip, and is sealed apart from the flue liner so the two can move separately. Sealing crown cracks typically runs $150 to $550, and a new crown with a drip edge $800 to $2,500.

Gas furnaces in old clay flues

With most of Glenside on gas, the old chimney mostly carries exhaust from a furnace or boiler plus a water heater. Gas exhaust carries a lot of water, and in a clay flue that is cracked or was never lined the moisture condenses and eats at the joints from inside. Current code says masonry chimneys shall be lined and the liner must suit the appliance connected to it.

After a furnace upgrade, check the water heater. If the new furnace vents out the side wall and the water heater stays in the chimney, the flue is now far too big for it, and code says it must be resized. A furnace or boiler stainless liner typically runs $2,100 to $3,800.

  • Furnace and water heater flue liners
  • Stainless caps ($200–$700) to keep rain and animals out
  • Top-sealing dampers ($140–$420) for drafty fireplaces
  • Smoky fireplace fixes ($140–$700)

Weather and the 2016 storm

Glenside sits between the Center City and Norristown NOAA stations, which average about 62 and 107 nights a year at or below freezing. Wet brick that freezes again and again is how spalling starts, and old chimneys have had decades of it. In the January 2016 storm the National Weather Service reported 15 to 24 inches across the Philadelphia metro.

Parts of Glenside we cover

Keswick Village · Ardsley · Wyncote · Edge Hill · Laverock · Abington Township · Cheltenham Township · Jenkintown · Elkins Park

Answers

Asked in Glenside

Our Glenside chimney is from the 1920s. Is it safe to use the fireplace?

Possibly, but check first. At that age the clay liner, smoke chamber and mortar joints are often worn. We inspect the fireplace and flue for free and tell you what we find, with photos, before you light a fire.

Someone patched our chimney with cement and now bricks are flaking. Why?

Mortar harder than the brick forces moisture and movement into the brick, which then spalls. The National Park Service recommends repointing with a softer mortar. We price the fix at the inspection.

Do I deal with Abington or Cheltenham for permits?

Glenside is split between the two townships, so it depends on your address. We check what your township requires for your job before work is scheduled.

Why does our basement smell like smoke or soot in summer?

Humid air reacts with soot left in an unswept flue, and a downdraft carries the smell in. A top-sealing damper, typically $140 to $420, usually helps along with a sweep of the flue; we check at the free inspection.

What does chimney cleaning cost in Glenside?

The sweep price is written down during the free visit, before work. Visits are Sunday to Friday; we phone first to confirm your window.

Rooftops of brick row houses in the foreground with the Center City Philadelphia skyline behind, on a sunny day

Schedule

Glenside visits, no charge to look.

Sunday through Friday, arrival between 8 and 11, 11 and 2, or 2 and 5. The look costs nothing, and a person phones you the day before.

Or call (267) 389-9644

Call (267) 389-9644